Industrial pressure washing removes adhered dirt from suitable yards, floors and plant exteriors. We assess the surface before selecting pressure and cleaning agents. Where oil has accumulated around production, washwater containment and recovery are planned before washing starts.
Industrial Pressure Washing
Industrial pressure washing for suitable floors, yards and plant surfaces, with controlled spray and contaminated-water recovery.
HomeIndustrial Pressure WashingIndustrial Pressure Washing enquiry
Pressure, surface condition and washwater
Weak concrete, damaged coatings and exposed joints can deteriorate under concentrated spray.
Drainage control
Contaminated washwater is contained and kept out of unsuitable drainage routes.
Pressure, surface condition and washwater
Weak concrete, damaged coatings and exposed joints can deteriorate under concentrated spray. A trial establishes the surface response and whether compatible degreasing is needed. Increasing pressure can damage the surface without improving removal. Washwater carries the released oil and particles, which means the collection route must be suitable for the contamination involved.
Discuss industrial pressure washing
Complete the form and we will get back to you.
Controlling spray and drainage
We separate the washing area from pedestrians and vehicle movements. Electrical equipment and stored products are protected from spray. Drain destinations are checked before work, with contaminated liquid contained and recovered through an appropriate route. Any discharge of trade effluent to the foul sewer needs the relevant water-company agreement.
Staining, wear and further preparation
We inspect for remaining deposits and distinguish them from staining or surface wear. General pressure washing does not establish that a surface is ready for repainting or hygienic production. Those uses may require further preparation or verification, which should be agreed before accepting the cleaned area.
Yards and external working areas can contain more than one drainage system. Washwater collection is established before washing begins, and temporary containment needs to remain effective throughout the job. Disposal or discharge then reflects the actual contamination and any cleaning product used.
Industrial Pressure Washing: common questions
Can industrial washwater enter a surface-water drain?
Polluting washwater must be contained and kept out of surface-water drainage.
Is pressure washing suitable near electrical equipment?
Electrical hazards need isolation and protection; uncontrolled spray is unsuitable.
Does washing prepare every surface for repainting?
A coating system can require additional surface preparation and acceptance checks.
Will higher pressure remove every mark?
No. Some marks reflect absorbed staining or damage, and excessive pressure can harm the surface.
Are cleaning chemicals always needed?
Their use depends on the deposit and the material being treated.