Industrial floor cleaning removes the contamination that ordinary mopping leaves behind on production floors and working routes. We treat oily deposits, tracked dirt and traffic marks according to the existing finish. Where a walkway remains slippery after routine cleaning, the residue and cleaning method both deserve attention.
Industrial Floor Cleaning
Industrial floor cleaning for concrete and resin surfaces, with suitable degreasing, dirty-water recovery and controlled reopening.
HomeIndustrial Floor CleaningIndustrial Floor Cleaning enquiry
Concrete, resin and traffic contamination
Bare concrete can absorb oil, while resin floors may be damaged by unsuitable chemicals or aggressive pads.
Traffic control
Wet sections are separated from pedestrians and vehicles until the floor is ready to reopen.
Concrete, resin and traffic contamination
Bare concrete can absorb oil, while resin floors may be damaged by unsuitable chemicals or aggressive pads. We inspect the finish and test a representative area before wider treatment. Scrubbing needs enough contact to lift the deposit, followed by recovery of the dirty liquid. Residual detergent can leave the floor slippery after cleaning.
Discuss industrial floor cleaning
Complete the form and we will get back to you.
Safe routes during floor cleaning
We phase the work around pedestrian and vehicle routes. Wet sections are kept out of use until ready to reopen, with equipment positioned clear of emergency access. Collected washwater is kept out of surface-water drainage. Machine bases and floor joints are included only where they can be reached safely.
Cleanliness, staining and slip performance
The final check distinguishes remaining contamination from permanent staining or wear. Cleaning can expose failed resin and damaged joints, but it cannot repair them. Where measured slip performance is needed, that assessment remains separate from the appearance of a clean floor.
If further scrubbing begins to affect the floor finish without improving the mark, the treatment is stopped rather than damaging the surface.
Industrial Floor Cleaning: common questions
Will cleaning remove every oil stain?
Absorbed oil may leave a visible stain even after removable surface contamination has gone.
Does cleaning repair a worn resin floor?
Cleaning cannot rebuild damaged resin or repair broken floor joints.
Can the whole floor remain in use?
The treated zone must be kept clear; other routes can remain open under an agreed phased plan.
Why does the floor feel slippery after washing?
Residual detergent or incomplete soil removal can contribute; the cause needs checking against the floor finish.
Is slip testing included?
Only when specifically agreed. A visibly clean floor is not a slip-test result.